I bought a new CNC router and I think the power supply is too small. I have 3 PacSci Powermax II P22nrx .... 2.3 amp bipolar, 65 v stepper motors. The motor tag also reads 74 w. Maybe that is watts but I don't know.
The power supply tag reads 48 volts and 3.2 amp. It is a switching power supply that two sets of 48 volt leads from it. I assume that it is dual channel because of the two sets of leads.
Is this a proper power supply? Someone told me that I could even use a 24 volt power supply if it had enough amps.
Any comments appreciated.
Thanks,
JR