I'm trying to use the auto settting to determine the correct amount of steps on each axis. However, each time I'm off by a few thousandths and try to get closer, mach three comes up with some out of this world umber of steps to change it to tho get to the target number. I'm using cnc masters mill, so i'm nort sure exactly what the leads are on the screws, I'm thinking they are 10mm. I'm also using gecko 201's which are rated at 10 and the motors i'm sure are 200 steps per rev. I'm not sure how to calculate it so i've place ana rbitray number in for the steps. When i use 10400 it's real close, but everytimei try to get closer, mach comes up with some outrageous number to change it to.

I did check the native settings and changed it to inches, but it didn't seem to change anything
Please help
mark