So I'm setting up my mill and figuring out the steps per inch I'm swapping out the old dos base system on my servo impact mill to mach 3 i bought the g540 but didn't realize its stuck in 10x micro stepping??
my setup
387 nema 23 from keli
so 280 deg
x10 micro stepping =2800
5 to 1 belt drive = 14000 steps
5 turn to one inch ball screw= 70,000 steps per inch !!!!!!
that's a lot I'm not sure what mach 3 can even do I'm running a due core 2.4g