I am planning to get a G540 for a router under construction. I am looking at two power supplies form keling and The KL-5020 seems good but based on the current draw the voltage drops significantly.
http://www.kelinginc.net/KL-5020.pdf
I was also looking at the KL-5413.
http://www.kelinginc.net/KL_5413.pdf
Can I use any of these two power supplies safely based on the lower voltages as the current draw increases?
I was also thinking of pairing the G540 with either of these two motors, wiring them in series of course.
http://www.homeshopcnc.com/RSstepperMotors2.html
HomeshopCNC Nema 34 600 oz/in RS34-600
or
HomeshopCNC Nema 34 960 oz/in RS34-960
Jason