Hi, no, sorry! We're still in small order production, and spending all resources on OEM sales. It's most likely still too expensive for the usual expectations of DIY'ers because we are not in high production yet, and do not buy cheap bearings. I haven't even had the cost of this one worked up, as it's not a product as shown.
The belting will not go well with molten metal spatter. This one will be the test bed for cutting accuracy and debris management.
All in good time.
Shouldn't show it if I can't sell it, but alas, wanted to show you how it's going!
I will however be pushing for a 4x8 kit to offer at some point. Got a lot of testing to do before that's something I'll stand behind! We're getting closer.