I would like to get some t-slot covers for my mini mill - any recommendations? I mostly have a Kurt vice mounted so I'm looking for the individual snap in type.
Thread: t-slot covers
Results 1 to 6 of 6
-
11-13-2009, 07:00 PM #1
Registered
- Join Date
- Mar 2007
- Posts
- 100
t-slot covers
-
11-13-2009, 09:56 PM #2
Registered
- Join Date
- Jul 2005
- Posts
- 340
once I made mine on my own , wasn`t so difficult.
-
11-13-2009, 10:36 PM #3
Moderator
- Join Date
- Mar 2003
- Posts
- 927
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
-
11-15-2009, 02:40 AM #4
Registered
- Join Date
- Jan 2009
- Posts
- 237
plywood! Cover the entire surface cut to fit the vise.
A/C exterior!
-
11-15-2009, 03:19 AM #5
Moderator
- Join Date
- Jan 2006
- Posts
- 4396
www.use-enco.com
They sell the ones for Bridgeports so I assume they might have some for your Mini Mill.Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com
-
11-16-2009, 12:50 AM #6
Registered
- Join Date
- Sep 2006
- Posts
- 59
We used 5/8 x 1 cold drawn flat stock on our VF5.
It fits the slot width perfectly and comes up just to the bottom of the chamfer on the slot, leaving no crevices for chips.
Reply With Quote
Similar Threads
-
Way covers.
By BlackMoon in forum Charter Oak Automation Support ForumReplies: 13Last Post: 10-24-2009, 05:09 AM -
vf3 way covers
By mls in forum Haas MillsReplies: 2Last Post: 02-03-2009, 02:41 PM -
cutting a slot with a t-slot cutter
By cncuser1 in forum MastercamReplies: 11Last Post: 09-10-2008, 03:02 AM -
Way Covers For SX3
By Old Megawatts in forum Syil ProductsReplies: 9Last Post: 06-15-2007, 05:03 PM -
Coated Carbide 4Flute Endmill, 3Flute Slot Drill, or 2Flute Slot Drill?
By weaston in forum MetalWork DiscussionReplies: 7Last Post: 04-12-2007, 03:00 AM
Posting Permissions
