Nop, there will be no "dedicated PC" to run the tool. Any computer from local LAN can be used. This means anybody could use it's notebook to run the toolOriginally Posted by daedalus
Beat that!
View Poll Results: Would you participate to develop an open-source CNC controller (ETH,FPGA,WIN+Linux)?
- Voters
- 135. You may not vote on this poll
-
Yes, I will install required software, and participate
61 45.19% -
I will test your solution, hardware and software
39 28.89% -
I will test, only if I can buy dev. board.
11 8.15% -
No, I don't have resources (time/money/etc)
24 17.78%
Results 1 to 20 of 32
Threaded View
-
12-05-2009, 10:26 PM #25
Registered
- Join Date
- Sep 2006
- Posts
- 218
Reply With QuoteSimilar Threads
-
Smoothie CNC controller, Open Source.
By Rolf_K in forum Laser Engraving / Cutting Machine General TopicsReplies: 6Last Post: 01-15-2015, 07:41 PM -
CNC Controller with Arduino - open source
By Christian Knüll in forum Open Source Controller BoardsReplies: 16Last Post: 12-22-2012, 10:46 AM -
Open Source 3 Phase BLDC controller
By karl1 in forum Open Source Controller BoardsReplies: 0Last Post: 02-10-2009, 11:35 PM -
Open Source CNC Controller Specification
By gregmary in forum DIY CNC Router Table MachinesReplies: 28Last Post: 12-05-2005, 04:58 AM -
BEST Open source Controller ?
By Seventeen in forum Open Source Controller BoardsReplies: 12Last Post: 09-22-2005, 12:27 AM
Tags for this Thread
Posting Permissions
