G-codes will be pretty standard from control to control depending on if it is a lathe or a mill. However when you get into some of the non standard M-codes you have to be careful. These can mean different things and are dictated by the MTB. If you need to know specifics of your machine then you should call the MTB and get the proper list. Also some G-codes will be different depending on the G-code system you are using A,B,C.

I also attached a spreadsheet with some info regarding system variables, programing etc. that may help. Can not get the spreadsheet to attach to this post. Attachments must be down so I will try later.

Stevo