603,335 active members*
3,637 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > UHU Servo Controllers > Current Schematcs & support information

Thread: Current Schematcs & support information

Results 1 to 6 of 6

Hybrid View

  1. 03-16-2010, 04:57 PM #1
    tenmetalman
    tenmetalman is offline Registered
    Join Date
    Jan 2006
    Posts
    297

    Schematic, Current rev. B + rev c for power stage

    Post #1 still is the correct information for the latest schematic support
    Reply With Quote Reply With Quote
  2. 07-09-2010, 04:59 PM #2
    tenmetalman
    tenmetalman is offline Registered
    Join Date
    Jan 2006
    Posts
    297

    Current Schematics

    Let's try this again. Hopefully here's the schematics for the UHU.HIGHPOWER
    PCB
    Attached Thumbnails Attached Thumbnails img042.jpg   img043.jpg   img044.jpg   img045.jpg  

    img046.jpg   img041.jpg  
    Reply With Quote Reply With Quote
  3. 08-04-2010, 05:30 AM #3
    tenmetalman
    tenmetalman is offline Registered
    Join Date
    Jan 2006
    Posts
    297

    wrong wiring on img.041.JPG, J8-J9 previous post

    I just noticed that the above drawing is labeled WRONG. see the enclosure with this post for the correct hook up. the drive shown is an old one when I was mounting the 470uF 200v capacitor on the P2 terminals due to a height clearance problems
    Attached Thumbnails Attached Thumbnails img047.jpg  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 10% discount SBR16 linear shaft support+SFU1605+bk12/bf12 support+6.35*10 coupling
    By yvesleeok in forum News Announcements
    Replies: 0
    Last Post: 07-27-2013, 06:44 AM
  2. Max length for an acme threaded rod. End support or fully support the frame?
    By dlpaul in forum DIY CNC Router Table Machines
    Replies: 7
    Last Post: 03-12-2011, 09:54 PM
  3. Low Current interface, High Current Motor?
    By Clackvalve in forum CNC Machine Related Electronics
    Replies: 15
    Last Post: 05-13-2010, 06:42 PM
  4. Information
    By Davey in forum MetalWork Discussion
    Replies: 15
    Last Post: 05-04-2006, 12:00 AM
  5. Please a need an information
    By giansa in forum Uncategorised CAM Discussion
    Replies: 5
    Last Post: 11-26-2003, 11:24 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules