Hello,
I have a Cincinnati milacron 1410 that has a Fanuc controller, It has a highland BTR on it with the cable cut, Can anybody help me with the wiring and how to get it talking?
Thanks
Hello,
I have a Cincinnati milacron 1410 that has a Fanuc controller, It has a highland BTR on it with the cable cut, Can anybody help me with the wiring and how to get it talking?
Thanks
Which Fanuc control is it?
Hello,
It is a Fanuc 11TT.
Thanks
Sorry, I don't have any manuals nor info for that control. Try searching for DNC, RS232, etc. This has been covered for most controls many a time.
Anybody else have 11TT control comm details?
Thanks,
I have the manuals for the machine and I can probably figure out the settings for it.
However I can find no info on the BTR board to figure out what the Pinout is on it.
The Cable that is cut has a Red, Black, White and green wire in it.
I would think that green is chassis ground, and the red and black are the comms and the white the signal ground?
OR it could be RS-422 without a chassis ground? I kind of doubt this option.