[Jesse B]

I haven't done much on this for the past couple days since I've been building and installing a power drawbar on my Syil X3. I'm looking for easier faster toolchanges. I was getting tired of the stupid wrench. It works, now just to hook up a switch. Eventually i'm going to have a tool table as well, but that's going to be a little while down the road too yet. Hopefully i'll get back to the router designing in a day or two.

I'm trying to figure out on the router how I want to support the lead screws, and what KIND of leadscrews I want to buy. I'm tempted to do ACME screws, just because they are cheap and i'm going to 405oz steppers geared at 3:1 to run them, but, my "overengineering" says go ball screws. I'm trying to the best pricing I can.

Wade

If you end up going with Acme screws, I'd recommend getting either a low TPI, or a multi-start screw. Looking great thus far though