.
Hi Dave
Not sure if I did it the correct way but it seemed to work OK, you would be the best judge of whether the geometry is now what you wanted !!
Anyway, here is what I did :-
1) Went to "Utilities" then to "Break" then to "Divide" and broke each of the circles that had the be "joined" by the 0.18 rad into 4 (Quadrants).
2) Next I went to "Arcs" then to "Fillet" and set it to the 0.18 rad required
3) Then did a normal fillet operation from one quadrant to the one on the other circle and the result is what I posted.
Worked out pretty easy really
Have a go yourself and see if it works for you, FYI I am on Build 1493
Regards
Rob
:rainfro::rainfro:
.