587,228 active members*
6,604 visitors online*
Register for free
Login

Thread: homeing

Results 1 to 5 of 5
  1. 06-21-2010, 11:13 PM #1
    frankg521
    frankg521 is offline Registered
    Send a message via AIM to frankg521
    Join Date
    Aug 2006
    Posts
    119

    homeing

    the x is the ony axis that homes... the y and z just go to the home switch and stop it dosen't come off the limit any help is this a setting???
    Reply With Quote Reply With Quote
  2. 06-21-2010, 11:21 PM #2
    ger21
    ger21 is offline Community Moderator
    Join Date
    Mar 2003
    Posts
    35538
    Try increasing the debounce in General Config, top right corner.
    Gerry

    UCCNC 2017 Screenset
    http://www.thecncwoodworker.com/2017.html

    Mach3 2010 Screenset
    http://www.thecncwoodworker.com/2010.html

    JointCAM - CNC Dovetails & Box Joints
    http://www.g-forcecnc.com/jointcam.html

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
  3. 06-21-2010, 11:25 PM #3
    frankg521
    frankg521 is offline Registered
    Send a message via AIM to frankg521
    Join Date
    Aug 2006
    Posts
    119

    thanks

    thanks for the quick reply ger21
    Reply With Quote Reply With Quote
  4. 07-06-2010, 10:50 PM #4
    frankg521
    frankg521 is offline Registered
    Send a message via AIM to frankg521
    Join Date
    Aug 2006
    Posts
    119
    hi ger21 that worked great can u tell me how to connect spindle motor single phase 110
    i have it connected to the mist port is thier a better way
    Reply With Quote Reply With Quote
  5. 07-07-2010, 12:01 AM #5
    ger21
    ger21 is offline Community Moderator
    Join Date
    Mar 2003
    Posts
    35538
    IN the Spindle Tab of Ports and Pins, right above the mist and Flood, assign the output to Clockwise.
    Gerry

    UCCNC 2017 Screenset
    http://www.thecncwoodworker.com/2017.html

    Mach3 2010 Screenset
    http://www.thecncwoodworker.com/2010.html

    JointCAM - CNC Dovetails & Box Joints
    http://www.g-forcecnc.com/jointcam.html

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. help Homeing fadal vmx15 no experiance
    By One eye doc in forum RFQ Feedback
    Replies: 3
    Last Post: 12-13-2009, 08:43 PM
  2. Homeing
    By frankg521 in forum Mach Mill
    Replies: 7
    Last Post: 08-01-2007, 01:21 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules