[CDTooling]

We are pleased to present our premium quality line of Annular Cutters. These are a great alternative to drilling or boring holes.



http://www.carbideanddiamondtooling....ble-_p_825.htm

[email protected]

Phone 716 791 6197 Fax 716 625 1312
Distributor Inquiries Welcome

[DanOSB]

wondering if you can use this bit on a drill press.. is there a adapter for that?

if so will 5/8 shank drill work? also does it have spring system for ejector?

Thanks
Dan

what is the pricing for that adapter

[CDTooling]

Yes these work great with a drill Press. They take much less power than a twist drill. Below is the link for the page you asked about the drop down menu shows prices for all items. We were not sure what you were asking if it was the price of a 5/8 cutter it is 5-530-116 $27.61. an ejector pin is 5-530-905 $5.61. Not knowing the size of your drill press We could not say what arbor you need they run 7-980-100 $61.49 and up.
If we may be of further assistance please contact us with below contact information.

http://www.CarbideAndDiamondTooling.com

Best Regards,
Marty
716 791 6197
[email protected]

http://www.carbideanddiamondtooling....tible-_p_825.h

[DanOSB]

i was looking for soemthing i can use with 1/2 inch or 5/8 chuck on the drill press instead of changing the arbor.. just leave the drill the way it is..

is this more clear?

Cheers
Dan

[CDTooling]

Yes you could use the 1/2 dia arbor and just change the cutters
Best Regards,
Marty

[prman]

We are located in the states and were looking to add an Annular bit sharpening machine. Would anyone have any suggestions for sharpeners to look at? Thanks.

[keebler303]

Maybe look for something like this?

DAREx - E90 End Mill Grinder And Sharpener