[mafitch7479]

Go to the program parameters and change the suface finish quality to a higher figure. Also, try adjusting the tool path tolerance to a larger number. See what it's set at now and change it by half again.

What exactly do those settings adjust? I don't want to change anything that might mess up a future program.

Our dealer had the boss reset a few connections in the back of the machine, so we're going to see if that fixes it. If not, we'll try changing these settings.

By the way, what probing system do you have fitted to that? I've fitted dozens of Renishaw part, tool and laser probes to Hurcos and don't get problems with them.

We've got a Renishaw probing system, that's way underused by our current machinist, but will likely get used a lot more when he retires.