[ncdeftones]

So your about a .25" off from the factory spec?

Without taking my rear rubber guard off that protects my screw below, im getting about 63 turns on the hand wheel @ .10" = 6.3"

I'm sure i could get an easy 1/2"+ more if i removed the rear rubber guard.

Ill check my other G0704 as well, and also remove the rubber and see what i get.

Thanks for checking. I'm not really complaining...I'm just wondering how Hoss has got more travel cause that little bit extra makes a world of difference to me with making a particular part. I can cut out the center section now, but only by .020" to spare with a 1/2" end mill or larger and then I'm going to have to reposition the part to finish the outside edges.