I've read other discussions here about one brand CNC router vs. another, but I would like to hear some opinions on the specific machines I'm looking at. If anyone has personal experience with the machines listed below I welcome your comments.
I have been in the machining industry for 20+yrs but only recently became familiar with CNC routers. I'm looking for a new or used router that can handle cutting 1/2" phenolic on a daily basis with summertime temps over 100 degrees. The only router I have programmed was a Komo Mach 1 with a 5x12 moving table. So far I have seen demos on:
Onsrud Panel Pro 145G18D
Multicam 7000 series
and I have an appointment to see a SCM Pratix N15
These are all moving gantry machines which I'm not familiar with. The Onsrud impressed me but is pricey. The Multicam is nice but I have an issue with no full controller at the machine. I have never even heard of SCM before so...
Thanks in advance.