I'm getting a little further. Found that the rotary table was set to removed on the pendant.

For future reader reference, while control is powered on and before turning on machine power, go to pendant, click setup, hit more-> until you find ROT, select and you will find 'A' with two options. Present and Removed. Click Present.

Once this is done, power on the machine and the align will also align the 4th axis.

On to my current problem...When the machine is aligning the 4th axis, it rotates the table about 2 times, eventually the screen shows A at 359.95 but never completes the alignment. I'm pretty convinced the default parameters on the new hard disk are wrong. Does anyone have the parameters for a Cincinnati branded Troyke DL-6-B rotary table ?

-Art