Hi All,
Not sure what is going on here, but I have wasted quite a bit of good Oak trying to fix the problem. Hoping one of you can shed some light on the problem.
I am using two tools 1st is a 19mm Flat End with a length of 30mm. This is programmed into the tool library correctly and is being used for horizontal roughing.
My second tool is a 3mm end mill with a length of 19mm. Again I am sure this programmed correctly into the tool library. I am using this tool for horizontal finishing.
Running the simulation all looks great, however when on the machine. The 19mm tool does what it is supposed to but when I put in the 3mm tool it starts cutting about 3mm above the level of the original stock material.
Unless I lie about the length of the tool I just don't know what to do.
I have attached some images of my tool config for both these tools.
Any suggestions would be greatly appreciated.
Thanks
Simon