Hello to all,
As I mentioned on previous reply I changed parameter 390.7 back to 0 instead of 1 to see what would happen. NOTHING !!! That didn't make a difference. I'am still getting the 14 lines send.
What I did find out is that I'am only getting a DC2 when sending from controller to pc at the beginning of the terminal. No DC3 or whatever at the end.
From what I've read here on posts, it's suppose to be a DC1 and DC3.
I'am getting exactly the same on the other mill where DNC works just great!
I have no clue what the differences are between DC1, DC2 and DC3.
http://www.cnczone.com/forums/fanuc/...tml#post850654
That's all for now.
Thanks