Compiling errors found and corrected. I found four print "Reset" commands that had a missing quote at the end, once added the java stack overflow error was eliminated . I also had a compile copy error, that was trying to print a undefined variable " DegreesetKey()". I had to comment it out in order to get the sketch to compile without errors. I'm not sure of the variables function. I am now able to upload the sketch and finish the project.
try this just unzip it it should be fine
Dan, thanks for the download, it compiled without a hitch. Bob
Are there any good updated Arduino sketches, for the indexer, using touch screen LCD or LCD2004 & keypad? Bob
you can do it if you wont:devious:
it would not be that hard its just mapping of the buttons that need done or where on screen the buttons are
http://danielscnc.webs.com/
being disabled is not a hindrance it gives you attitude
[SIGPIC][/SIGPIC]
Thanks, I will give that a try. Bob
I made some changes to the sketch and added a few functions that help in the initial setup and operation.
I'm having some problems with this, it is compiling ok. When I turn it on the stepper instantly will run for about 2 seconds and then the lcd will flash for a little while and sometimes I will get 0 0 near the bottom of the screen. Any idea what could be wrong?
Thanks
I'm not sure why it's not working. The only problem I had was in using the correct libraries and make sure that pin 12 is STEP and 13 is set for DIR and that the keypad is using pins 4 through 11.
PM me your email and will send you the libraries that I used. Bob
PM sent
Ok, Have got it working now, thanks for the files. I had LiquidCrystal_I2C.o missing for some reason.
hello , i ran across your program it is just what i am looking for , just downloaded thank you. the program doesn't run newer version of arduino problem with liquid crystal_i2c lcd(0x27,20,40); line "invalid conversion from 'int' to 't_backlighPol'[-fpermissive] im new to the programming stuff have no clue about it thanks
you need LiquidCrystal_I2C librarie post a pick of the error it should say what is missing
http://danielscnc.webs.com/
being disabled is not a hindrance it gives you attitude
[SIGPIC][/SIGPIC]
do you have this one https://github.com/fdebrabander/Ardu...al-I2C-library
http://danielscnc.webs.com/
being disabled is not a hindrance it gives you attitude
[SIGPIC][/SIGPIC]
thanks i will try it
it is a problem with the new version of arduino I cant get it working ever some words are wrong hit the same problem its the starting of the screen (int screen)
http://danielscnc.webs.com/
being disabled is not a hindrance it gives you attitude
[SIGPIC][/SIGPIC]