hey,
i finally finished my upgrade. Now i need to trim the surface. from 0.085 to 0.000 any tool recommented to this job.
The material i used to do this project:
1/2 steel plate 19x30
18, M6 hex screws
Quarter inch finish plywood
M6 inserts.
hey,
i finally finished my upgrade. Now i need to trim the surface. from 0.085 to 0.000 any tool recommented to this job.
The material i used to do this project:
1/2 steel plate 19x30
18, M6 hex screws
Quarter inch finish plywood
M6 inserts.
PS.
i guess i can't use this tool, Unless i trim the shaft down to 12mm, to make fit ER20 collet #12.
Any ideas
Surfacing that plywood is not going to result in a very good finish.
You'd be better off adding some MDF on top and surfacing that.
Just get a cheap bit like this.
https://www.amazon.com/Yonico-14973-...480408&sr=8-28
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
hey,
I'm Thinking of Upgrading my Stepper Motor's to --> Closed Loop Stepper Motor.
I'm looking at two differen Closed Loop Stepper Motor.
1. STEPPERONLINE 1 Axis Closed Loop Stepper Motor Kit 2.0Nm 1000CPR Nema 23 Closed Loop Stepper Motor+0-7A 24-50VDC Stepper Driver+2 Extension Cable $106.99
OR
2. RATTM MOTOR, Nema23 3.0Nm Closed Loop Stepper Servo Motor 88mm 5A+HSS60 Hybrid Driver CNC Kit $145.99
Which one would will be a good choice?
Would appreciate a good feedback.
thanks.
Just fine out that (STEPPERONLINE 1 Axis Closed Loop Stepper Motor Kit 2.0Nm 1000CPR Nema 23 Closed Loop Stepper Motor+0-7A 24-50VDC Stepper Driver+2 Extension Cable)
It only a 2.0 283.28 Torque(oz.in)
And the next one up it a (E Series Nema 24 Closed Loop Stepper Motor 4.0 Nm(566.56oz.in) Encoder 1000CPR) Which is better. for $120.00