the hass mill you have might have a version of quick code this should help you with the feeds and speeds to get you in the general direction . other wise your machineries hand book will have the stuff you need . cnc is just like manuale machining you still need to follow the baiscs.
Thread: Need help in Indy.
Results 21 to 22 of 22
-
02-27-2007, 06:38 AM #21
Registered
- Join Date
- Feb 2007
- Posts
- 10
-
03-08-2007, 04:01 AM #22
Registered
- Join Date
- Dec 2006
- Posts
- 84
I'm sorry I didn't pay attention to the fact you weren't pecking. If you're doing a lot of holes and not pecking, you could always just drill with G01, and then rapid out of your hole and then over to the next hole location.
G00 Z0.1 (Z .1 OVER PART)
G01 Z-0.75 F10.0
G00Z0.3
X1Y1
Z.1
G01 Z00.75 F10.0 etc..
It's going to be more code, but if I'm not pecking I normally set it up to drill with G01. I usually have faster cycle times when I'm not instating canned cycles.
Reply With Quote
Posting Permissions
