[murad]

I have a yang smv-1000 cnc machine with a fanuc 0M-D controller which stoped working this morning when i tried to home the z axis
the z axis went to it's home position and the home position led turned on but after that an error message( Error No. 1001 LUB time over) appeared

can any one please tell me what does it mean and what caused it ?

I searched every where on the internet to figura it out but i didn't find any thing because the error messages above 1000 are for the manufacturer (yang cnc) and not for the fanuc 0M-D controller

yours murad

[underthetire]

The machine didn't get proper lube pressure in the specified time.
Causes:
Bad pump
Bad pressure switch/broken wire
Broken line
Stuck metering block
Dirty filter/tank

[murad]

Thank you underthetire for your reply,
I will check my machine lube today, but is there any key i could press to bypass this error to mack sure every thing is ok because i know that my machine (yang smv1000) lube manually (without pump)

my controller model is fanuc 0-MD

[avtechmachine]

Press RESET + FEED HOLD to reset alarm 1001, but make sure to grease all three axis after reset alarm

Ahn Vuong
[email protected]

[murad]

Dear avtechmachine,

Thank you very much i tried it and the problem solved

[rymannphilippe]

Hello i have the same problem after 10 years now for the first time.

My YANG is also with manual lubing and now it shows the ERROR 101 LUB. TIME OVER.

Press RESET & FEED HOLD worked absolutly fine and now we can go back to work.

For Germans:
YANG Fräsmaschine mit dem Fehler ERROR 101 LUB. TIME OVER
Entweder ist es ein wirkliches Problem der automatischen Schmierung oder wenn die Schmierung manuell ist ein Hinweis dass man mal wieder schmieren sollte.
Um den Fehler zu löschen einfach RESET und VORSCHUB STOP drücken.

Gruss aus der Schweiz
Philippe

Greetings from SWISS
Philippe