Hi folks,
After perhaps a hundred small projects i've killed my Kress FME 1050. The bearings collapsed and caused the motor to 'burn out'. bummer.
I can't really justify another £160-£180 on another Kress as it hasn't really worked that hard. What are my options?
I was considering butchering the Kress to remove the collet chuck so that i could then use it ( and the full set of collets i have for it) held in a relatively inexpensive variable speed wood router and when that router died, i could then just move it onto another one.
Your comments/advice would be greatly appreciated.
Regards,
David