Hello!

I want to build a Tachus42 3 Axis Board stepper controller and as I am a total newby, I have one question! I want to use it with PM35L-48 printer motor (datasheet: http://www.eminebea.com/content/html...f/pm35l048.pdf) an if I have 24v volt power supply do I need ressitors from my stepper motor to power supply and how big must be current rating for power supply if I use three of these motors!

And, can anyone tell - could I use these motors for small 8x8 inch cnc router table just for drilling precious holes in pcb's!????

Thank you!