588,354 active members*
7,887 visitors online*
Register for free
Login

Thread: 10 wire stepper

Results 1 to 4 of 4
  1. 01-05-2004, 01:09 AM #1
    xairflyer
    xairflyer is offline Registered
    Join Date
    Nov 2003
    Posts
    314

    10 wire stepper

    Hi Guys,

    I have a 10 wire berger lahr stepper motor 1.4A, 2.3 ohm I have measured it and there is 5 coils.

    I am stuck as far as knowing how to connected it.
    Reply With Quote Reply With Quote
  2. 01-05-2004, 02:25 AM #2
    balsaman
    balsaman is offline Registered
    Join Date
    Mar 2003
    Posts
    2139
    I don't *think* it can be used on a regular unipolar or bipolar drive. I could be wrong, but I am pretty sure it's a whole different animal.

    Eric
    I wish it wouldn't crash.
    Reply With Quote Reply With Quote
  3. 01-08-2004, 08:19 PM #3
    xairflyer
    xairflyer is offline Registered
    Join Date
    Nov 2003
    Posts
    314
    Have I bought a white elephant ??

    10 wire steppers don't seem to be very common.
    Reply With Quote Reply With Quote
  4. 01-08-2004, 09:19 PM #4
    Stevenpats
    Stevenpats is offline Registered
    Join Date
    Sep 2003
    Posts
    18
    Berger Lahr and one other company make 5 phase stepper motors and controllers, but I have seen the controllers on ebay a few times. I have a couple of the motors that came on a 2-axis assembly, I robbed the encoders and bearings from them and they are in my scrap box.
    Steven
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 8 wire Stepper motor wiring connection
    By hornet in forum Stepper Motors / Drives
    Replies: 8
    Last Post: 01-25-2013, 07:52 AM
  2. Using Cat 5 cable for stepper motors?
    By 10bulls in forum CNC Machine Related Electronics
    Replies: 3
    Last Post: 04-24-2005, 04:24 AM
  3. 12 wire stepper
    By extreme in forum Stepper Motors / Drives
    Replies: 5
    Last Post: 03-25-2005, 12:56 AM
  4. How to Wire the Camtronics Stepper motors?
    By Cold Fusion in forum CNC Machine Related Electronics
    Replies: 3
    Last Post: 05-27-2004, 08:15 PM
  5. Correct Stepper Wire ? ?
    By Mr.Chips in forum Xylotex
    Replies: 1
    Last Post: 05-08-2004, 02:44 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules