Re: MX45VAE Will not move after startup
Last time I ran it I pulled out the tool but I tried with it in and out
hy, sometimes the claws that grab the pullstud may remain too long in an intermediate position, because of a wrong toolchange sequence; this may be caused by missalingment, because of manual toolchange, or because of swing arm - atc - spindle alingmnent
as a consequnce, the hydraulic will be up for for too long, over a preset timer, that will jump a fuse in the electrical cabinet
if you can not clamp/unclamp tools, then look for this; besides this check, i have no other idea / kindly
Ladyhawke - My Delirium, https://www.youtube.com/watch?v=X_bFO1SNRZg