[jevs]

I need some clamps for my Kurt Vise and I cannot seem to find anything. I need something like these clamps but for a Kurt:

http://www.glacern.com/photos/gpvr_01.jpg

What are these called and where can I get some?

I also found these, but none for 7/16 T-slots:

Forged Clamp Adjustable Asselby T-Slot 1/2" Brand New | eBay

Any ideas?

[RICHARD ZASTROW]

They used to be available as an accessory from Kurt. I would think they still are either directly or from a dealer that sells The Kurt vises.

Dick Z

[jevs]

I called Kurt today and they do not sell anything for mounting the vises. I did find this tonight and ordered. They should do what I need. You would not think something so simple took me hours to find in the 7/16" slot

LittleMachineShop.com - Clamp, Adjustable

[mechatronindo]

Hi, All..
Does anyone know about "Advantech", motion card maker in Taiwan.. How reliable is this product..? I try to use this product but I got difficulties about the control software.. What control software suitable for it.? Thankyou..

[rowbare]

Too bad you don't have a mill, then you could make some... ;-)

bob

[jevs]

I do have another mill, but I don't really want to make these when they are only $8. If I could whip them up in 15 minutes it might be worth it......if only I had as much time as when I was a teenager again.....

[mechatronindo]

Thank you, for advices, but please advice a better motion control card that I can get it in South east asia area..