trying to probe .125 dia, probe tip is .078, cant seem to control back off distance, runs into opposite side, is it possible to control with variable, using 9814
trying to probe .125 dia, probe tip is .078, cant seem to control back off distance, runs into opposite side, is it possible to control with variable, using 9814
Variable #562 controls back off distance of the probe. You can set it within your program:
#562=.015
Then, at the end of your probing routines, if you feel the need, just set it back to whatever is standard, which I think is .200".
If you are probing for size, you may want to verify you get good numbers with the back off so small.