Hey G'day folks,

After a small wait, my AXBB-E and UCSB are on the DHL train. Small annoyance, the UCCNC program I bought to run the UC100 I am reliably informed will not work with the AXBB-E controller.
Another license is required, sighh.

So back to mach3 I guess, my monthly budget is gone so UCCNC will have to wait if I decide at all to go back to it.

If anyone else has the AXBB-E and running it with mach3 would like to hold up their hand if there are any unexpected pitfalls to look forward to?

Cheers,
Steve