Not sure if anyone can help but I am trying to generate g-code for a part requiring 3 axis. I modelled the part in Solidworks and then downloaded FreeMILL. My machine runs Acurite MillPWR.

I have imported my part and it all looked good, picked up that the part was 232mm X 150 X 12.5mm but when I ran the code, it only made a part approx 9mm 4mm.

Have tried multipule times, uninstalled and reinstalled, but keep getting the same result.

It is like it has scaled it down but there is no facility for me to change the scale.

Am I expecting too much from freeware...any suggestions of other software?

Any suggestions greatfully accepted. Cheers