Hi all. I have purchased and older (1987) Daewoo Puma cnc lathe with a 6T control (Fanuc?) to add to my shop. I have 2 newer Haas cnc mills but haven't run a cnc lathe in a long while.
I use Surfcam for offline programming for the mills and am looking for a post or some sample code for the Puma lathe that will at least get me close to making useful code here on my lathe. I have a manual (poor documentation) but I cannot find any samples of nc code to work from or to modify a surfcam post.
Secondly, I currently send programs to the Haas mills with RS232 cable setup and would like to do the same for the lathe. If anyone can help me with that, I would appreciate it very much.
This site has always had very helpful information and I learn somthing new everytime. Thanks in advance.
Bob Flores
231-632-6669
[email protected]