If you hook the Arc Voltage Height control into the CNC Interface Port on the back of the 1250, all of the torches on and off commands will be received by the table itself. If you leave the remote on/off pendant in that port, then the machine will not be able to activate the plasma cutter through programming.
There is an Auxiliary option in the software itself if you need to be able to manually turn the torch on and off, which is usually rare and few between.
Mike @ Torchmate.com | www.Torchmate.com
Toll Free : (866) 571-1066 M-F 7:30am-4pm PST