[Biggermens]

Hello everyone

I have a OSP E100L controller on a MV-4020 Mill with a 4th axes and i am looking for the DNC-B option, not sure if the machine has it or not, i cant seam to find it.
I found a picture of it in the books, a 25 pin connector with a couple of toggle switches, i looked all over and cant find it,i may not even have that option
Do anyone know were its suppose to be ??? I found a RS232 in the back but it looks like the 4th axes is plugged into it and i don't see any toggle switches.
And / or were can i purchase this option to add on to this machine if i don't have it ??

Thank you everyone, Very Much appreciated.
Biggs

[OkumaWiz]

The dnc control panel is typically mounted on the door or panel of the electrical cabinet. It does have 2 switches on the control panel.

I doubt if Okuma would add the option on a control that is that old, but it's worth checking through your local distributor.

Best regards,

[Biggermens]

Ok, i will double check that, what about memory upgrade ??
I might be wrong, but I seen in the book what looks like all the
software / memory is on a compact flash card in the electrical cabinet ????
Would i be able to copy everything to a larger compact flash card and use it ???

Thanks
Biggs