Hello, I am using the G540 and my gantry is powered by a Y and A axis motor. They have been slaved and worked fine for years and now I added home switches and want to home them independently. I noticed when triggering the 'REF' Y axis it only brings the Y axis home and twists the gantry. What steps do I need to take to configure this properly, thanks.
Shawn
Results 1 to 2 of 2
-
07-11-2017, 02:00 AM #1
Registered
- Join Date
- Nov 2003
- Posts
- 452
How to configure for homing master and slave axis
-
07-11-2017, 06:22 PM #2
Registered
- Join Date
- Nov 2003
- Posts
- 452
Re: How to configure for homing master and slave axis
Hello, just clicking on REF ALL on the Program Run screen did it. But the A axis did not show movement or position on the Diagnostics. So you can't go by that apparently.
Reply With QuoteSimilar Threads
-
Slave axis is not synchronized with master
By Antrac1t in forum Machines running Mach SoftwareReplies: 4Last Post: 02-07-2022, 04:50 PM -
Slave axis moved opposite from Master axis
By jimskeet in forum Mach Software (ArtSoft software)Replies: 12Last Post: 08-01-2017, 05:33 AM -
Homing X-Axis A-Slave
By kaetamer in forum Avid CNCReplies: 3Last Post: 10-06-2015, 10:05 PM -
Homing Slave axis
By litleboy in forum Mach Software (ArtSoft software)Replies: 2Last Post: 05-20-2014, 07:19 PM -
need help with homing slave A axis in mach 1.83
By ozon in forum Canadian Club HouseReplies: 0Last Post: 07-02-2012, 10:19 PM
Tags for this Thread
Posting Permissions
