Hello everybody
I’ve got the following problem. When is tart the program (see attachment), it always stops before thread cutting (radial). My question is: is it caused by programming or by other things?
It’s the first time that threads are cut at this machine with powered tools.
Machine is Spinner TC110.
I listed the whole boring program. You never know where the mistake is.
Thread: FANUC 18i with Manual Guide
Results 1 to 5 of 5
-
01-09-2010, 01:40 PM #1
- Join Date
- Nov 2007
- Posts
- 270
-
01-09-2010, 04:56 PM #2
- Join Date
- Nov 2004
- Posts
- 2484
Hello
The manual guide B-63874GE/06 says:
G1112 thread cutting cycle for turning machines with moving tools.
Output via M-CODE
G90
G00 X(x1) Y(y1) Z(I-point)
G99
M29 S(spindle)
G84 Z(depth) R(R-point) P(pausing) F(feed)
X(x2) Y(y2)
X(x3) Y(y3)
G80
G00 Z(I-point)
Regards, Boern<b><br />Das dringendste Problem der Technologie von heute ist nicht mehr die Befriedigung von Grundbedürfnissen und uralten Wünschen der Menschen, sondern die Beseitigung von Übeln und Schäden, welche uns die Technologie von gestern hinterlassen hat.</b><br /><br />Dennis Gabor (1900-79), ungar.-brit. Physiker, Entwickler der Holographie, 1971 Nobelpr.
-
01-14-2010, 03:31 PM #3
- Join Date
- Nov 2007
- Posts
- 270
Hello Boern
It neither worked. I believe it’s a coupling problem. I’ll check it. Thanks anyway
-
01-14-2010, 04:52 PM #4
- Join Date
- Nov 2009
- Posts
- 366
Hello
I started your program at one of our machines.
Thread cutting works perfectly.
Does any error occur when the machine stops? If yes, then which one?
-
01-14-2010, 06:16 PM #5
- Join Date
- Nov 2007
- Posts
- 270
I inspected everything. It was a coupling problem.
Thanks for your replies.
Regards, Jays
Reply With Quote
Posting Permissions
