Hi.
I recently moved our Miyano and now It wont run. Ipress start and no hyd. come on but I get an alarm 401 servo.
I press reset but it just clicks in the panel and the alarm comes up again.
any ideas please.
Gasher
Hi.
I recently moved our Miyano and now It wont run. Ipress start and no hyd. come on but I get an alarm 401 servo.
I press reset but it just clicks in the panel and the alarm comes up again.
any ideas please.
Gasher
It helps if you give the the controller, If your hydraulics are not on then you don't have any power probabally to the servo's either, check the term 5&6 of the servo board if 110v missing, then you have a e-stop power problem more than likely.
You need to get the schematics out and do some logical trouble shooting.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Al the Man
Thanks for your reply.
The control is 6 T
Hope this means something to you.
Gasher
Try changing the phasing of the power to the machine
Swap any two wires.