My question is Partmaket output is a .cnc file. But I have to load a .prg into my Citizen swiss. How do I go about doing this?
My question is Partmaket output is a .cnc file. But I have to load a .prg into my Citizen swiss. How do I go about doing this?
You can just change the extension for now.
You should also put in a request to support and we can set the post to output the .prg extension for you.
Bill Cain
www.partmaker.com
we load ours with no extension just drop it off
With regards to deleting file ext. Are you running Citizen machines?
yes we have 6