Hi guys, on my V2XT the housing that contains the " Y " axis tooth belt and pullies had filled up FULL with fluid and rusted the heck out of both big & small pullies. This happend at the place i bought the mill from. Thay are in BAD shape! The mill will run with them but thay NEED replaced. Anyone have these parts and/or where is the place to get them now? thanks mike
Results 1 to 3 of 3
-
10-17-2005, 05:49 AM #1
Registered
- Join Date
- Apr 2005
- Posts
- 47
Wanted: V2XT servo/ball screw pullies
-
10-17-2005, 12:51 PM #2
Moderator
- Join Date
- Nov 2004
- Posts
- 3028
Try calling Hardinge. Do ou have the maintenance manual to get the part numbers?
Be aware that there were 2 different versions based upon the shape of the casting for the Y axis drive. One was a rectangle. The other had a "dog leg" shape to one side of the casting. Try calling Alan at 1-800-245-2598. He can adise you of the availability of these parts.
George(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
-
10-23-2005, 03:38 AM #3
Member
- Join Date
- Apr 2005
- Posts
- 460
Try bptpartsrus on Ebay they have a lot of nos parts from the auction .
Reply With Quote
Posting Permissions
