Hi,
I am working on a Plasmacam Model DHC. I was purchased as an auction item and I do not have the software disk, but I do have the PC that was hooked up to it with the software on it. I would like to see an example of what the header commands need to be. The whole unit was in a flood about 4 years ago. I have gone through the PC and have it working again. I have not connected it to the table and controller yet. I did power up the controller and it lit up. I would like any information on setting up the machine and would really appreciate someone emailing me a sample program to cut something simple like a circle or rectangle to test the machine to see if it will operate OK. I am planning on calling PlasmaCam to explore what possiblities of registering the machine with them so access the user forum, but we want to make sure the machine will even operate before incurring any more expense. We just want to find out if the machine will work, then proceed. If anyone can send me a program that will cut any part, I would sure appreciate it. Just trying to see if it would be worth proceding. Thanks My email is [email protected] if you can help. Thanks so much. I found the controller powered on, but when I tried in the software to connect to the controller, it failed. The controller powers on, but the pause light blinks and I pressed the Start button, but nothing happened. None of the other buttons move anything.
,