587,249 active members*
3,569 visitors online*
Register for free
Login
IndustryArena Forum > Material Technology > Material Machining Solutions > A36 Steel Speed and Feeds With A Mitsubishi Carbide Insert Mill

Thread: A36 Steel Speed and Feeds With A Mitsubishi Carbide Insert Mill

Results 1 to 2 of 2
  1. 10-07-2015, 05:49 PM #1
    Kinetic2090
    Kinetic2090 is offline Registered
    Join Date
    Jul 2014
    Posts
    2

    A36 Steel Speed and Feeds With A Mitsubishi Carbide Insert Mill

    Hey guys, I am going to machine a large plate of A36 steel (2.5" thick). There is a lot of slot milling and hogging out that I will have to do with two insert mill cutters I have on hand. One is 3/4 Dia, and the other is 1" Dia. I have chosen to use these cutters due to the number of inserts we have on hand/and lack of endmills. I have been researching online about A36 steel and there is alot of conflicting information. Basically all I am asking is what is a safe guideline for me to start out with these cutters in the following categories:

    -SFM?
    -RPM?
    -IPM (The slot mill cuts will be .1 D.O.C.)
    -Coolant or air blast?
    Reply With Quote Reply With Quote
  2. 10-07-2015, 09:21 PM #2
    Kinetic2090
    Kinetic2090 is offline Registered
    Join Date
    Jul 2014
    Posts
    2

    Re: A36 Steel Speed and Feeds With A Mitsubishi Carbide Insert Mill

    bump
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. OSG 3 flute carbide end mill in mild steel - Stupid slow recommended feeds
    By ChrisAttebery in forum MetalWork Discussion
    Replies: 3
    Last Post: 05-27-2014, 10:31 PM
  2. 3" 6 Insert Face Mill Speeds & Feeds
    By Chalkboard247 in forum MetalWork Discussion
    Replies: 6
    Last Post: 10-13-2012, 05:20 PM
  3. Carbide end mill in steel
    By CJdave in forum MetalWork Discussion
    Replies: 2
    Last Post: 04-07-2009, 04:14 AM
  4. speeds and feeds insert mill
    By mls in forum Haas Mills
    Replies: 5
    Last Post: 01-05-2009, 11:13 PM
  5. Cutting steel on lathe with carbide insert. Not smooth.
    By alexccmeister in forum MetalWork Discussion
    Replies: 18
    Last Post: 12-05-2008, 03:13 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules