Can anyone help me figure out how to fix "1102 X Axis following Error" ???
Can anyone help me figure out how to fix "1102 X Axis following Error" ???
Following error is generally the axis cannot keep up with the commanded move, is the axis moving? Does it Jump suddenly or not move at all?
Do you have 'Following Error Display' screen on this model ?
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
The axis, In this case "X", will stop in the middle of a program. I will get the error message and will have to reboot the machine to get the axis to move. Last night i adjusted the transformer on that axis and was able to finish a program with out a problem. I am still unsure if i resolved the problem. What should the following error be set at? I am set at .0293 right now.
Is this the set value or the reading of the Detected amount of FE?
The degree of setting amount will depend a lot on the type of machine and the tuning.
Test for tightness if it occurs at one spot etc.
You could increase the allowed following error value or try tuning the axis with a slightly more gain.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
MotionMaster and Western CNC use Fagor 8055, if your machine is one of these it may be wise to remove the ball screw cover and check the ball screw. Have seen this error on these machines when they are in dire need of cleaning, grease.....etc. X axis on these machines require weekly maintenance. Check belts, ball nut etc.
The following error is not "set" ideally the following error would be 0, however that's not possible. Any time a machine starts to fault out on this kind of parameter, you need to check the basics (loose wires, etc.), before jumping in to the parameter table.Software doesn't just change. Mechanical stuff does.
Have a read...
http://www.fagor-automation.com/CNC/...Axis_Setup.pdf
PS write down the old values before making changes, and change 1 parameter at a time.
cheers
----------------
Can't Fix Stupid
More info....
cheers
----------------
Can't Fix Stupid
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Hi Al: I was referring to the comment by carving 123 that you quoted.
regards
----------------
Can't Fix Stupid
Thanks, You were very helpful. Problem solved!!
Curiousity.......what was the solution?
Tightened all the wire conections and clean and lubed all guide bearings and cleaned both lead screws. No problems since.
can anyone help me figure out how to fix "delected error N=32, CNC: gen_blog (00001 CAC). press key
help me!
fagor error
can you help me figure out how to fix " delected error N=32, CNC: gen_blog (00001 CAC). press key