Hello All I Very Like Make a Little Cnc Machine
but i have problem is to
Please See The Picture Below
Hardware
-----------------
I buy 3 Axis Stepping Motor (Start Shaphon 23HS3002)
My Motor
Buy 3 Step Driver (MS-2H057M) And Set It
My Drive
Buy Pmdx-122 and Set It
Assembly In Box Below
Buy Dc 9V Adaptor
Conect Stepping Motor to conector
Connect All To Box and Pc By Db 25
Software
---------------
Install Win Xp sp2 And Optimisation it
Install Mach3 VR2.42
Conect pc to Board (Pmdx-122 )
Pic S09.jpg
restart System
(when System restart Relay in Board is On&Off )
Run Driver Test And Pic S1 in Below
Run Mach3Mill
1- Config - select native Unit and select MM's
2- Config -Port And Pin - Pic Below
3- I don't know, how set Motor tuning and other config . I have a problem - Motor in not work Properly. Film in Below
Do You Help Me .
tank's a lot
Mach3 , Config, Motor Tuning problem ( FILM OF MOTOR)