Originally Posted by
brouser1
Thanks for the reply, but CandCnc does not have specific instructions for the PowerMax 45.
Tom will most likely be on the board sometime over the weekend. I'd say he'll answer your questions when he sees the post.
Jim Colt can probably also help you. He also will most likely be on sometime.
If the HT45 hooks the same as HT 1000, HT 1250 etc. there should be several others that can help you through the hook up.
I'll be watching I am going to have to do the same thing with a HT 1250 G3.
Sorry I couldn't be more help at this time.
If it works.....Don't fix it!