Hello,
I am wondering if anyone here is familiar with calibrating the tool probe on a Doosan lathe?
The machine is a Doosan Lynx 220L equiped with the Q setter.
After probing tools the machine cuts approx .016" different than it is commanded to. I have re-calibrated the tool probe on HAAS lathes many times but can not seem to figure out which parameters or settings to change on the Lynx to correct this error.
When the machine was new everything cut fine within .0005" after probing, so the arm has ovbiously been bumped.
A walk through would be greatly appreciated.
Thanks,
Colton.