Does anyone know how to do a tool eye calibration on a Mazak Super Quick Turn 200MS? Need to do the same on a 250 MSY but it should be the same process.
We have to offset our X +.032 just to start a job.
Thread: How to calibrate Tool Eye
Results 1 to 3 of 3
-
02-28-2007, 01:44 AM #1
Registered
- Join Date
- Feb 2007
- Posts
- 8
How to calibrate Tool Eye
-
02-28-2007, 02:54 AM #2
Registered
- Join Date
- Feb 2006
- Posts
- 992
Machine B Parameter: B61 for OD and B63 for ID.
I am not sure you have to minus or plus from B61. For example B61=15344 + 320(320 is equal .032 since no decimal allow). Note: you have to change B63 half of .032(which is .015), if not ID will cut oversize by .032.
Hope it help.The best way to learn is trial error.
-
03-01-2007, 01:14 AM #3
Registered
- Join Date
- Feb 2007
- Posts
- 8
Thanks for the info. I couldn't find the parameter in any of my stuff.
Reply With QuoteSimilar Threads
-
How to align/calibrate/install first linear bearing ?
By Calico in forum DIY CNC Router Table MachinesReplies: 10Last Post: 10-25-2009, 05:00 PM -
How Do I Calibrate MY Centurion 6?
By TZ250 in forum Uncategorised MetalWorking MachinesReplies: 1Last Post: 01-13-2007, 04:17 AM -
calibrate the motion system
By webcruiser8 in forum DIY CNC Router Table MachinesReplies: 0Last Post: 11-27-2006, 09:07 PM -
Post your Tips/trick on how to align/calibrate Linear bearing X,Y,Z ?
By Calico in forum DIY CNC Router Table MachinesReplies: 8Last Post: 04-25-2005, 09:41 AM
Posting Permissions
