How do you move the B-axis into position for part ejection after
part catcher bucket is down?
I've seen videos on youtube that show it can be done.
Thanks
How do you move the B-axis into position for part ejection after
part catcher bucket is down?
I've seen videos on youtube that show it can be done.
Thanks
Not sure if these will help or not. The common command looks to be M131.
This is from an older TT2000SY with 18i control (using B):
N250(PART EJECT)
G30U0M9
G30W0M131
G53B0M10
M169
M116
M11
M114
M168
M0
And this is from a recent TT1800SY program with 31i control (using A):
N9998(EJECT PART **************)
M05P21
G28U0
G28W0
M956
M131(SS INTERLOCK RELEASE)
M310(PART UNLOADER TO SS)
M288
G01G98G55A-2.5F200.
M169(SS CHUCK OPEN)
M116(PART EJECTOR ACTIVATE)
G00G28A0
M12(PART UNLOADER RETRACT)
G28W0
M960(EJECT PART FIN)
M962
N9962M01
Didn't work.
I get Alarm light, gut nothing on alarm screen.
This is what I have programmed:
(UPPER TURRET)
N1000( PART EJECT )
M906
M98P1
T0100
M65
G0G54Z0
M310
G4U2.
M131
G55
G1G98B-3.F50.
M318
G4U2.
G59
G0G28B0
G4U2.
G54
M311
M907
M908( DWELL FOR CUTOFF )
M909
M131
M169
M910
G0G54B.1
M86
G1G98G31P99B-.75F10.
M87
M168
M911
M912
G1G98G31P99B-.7F10.
M87
G4U.5
G59
G0G28B0
G54
M913
M98P1
M914
M30
(LOWER TURRET)
N1000( PART EJECT )
M906
M98P1
M165
M907
M108
G4U2.
M109
M165
M908
N12( ISCAR CUTOFF - PART TRANSFER )
M909
G54( LOWER TURRET-LEFT SPINDLE )
M98P1
M5
T1212
M131
G97S840M203
Z-1.36M8
M910
M911
X3.
G1G99X1.2F.02
G50S2500
G96S200
G1X-.016F.0015
G0G97X1.3S2500
G0G28U0
M912
M913
M98P1
T1200
M914
M30
Thanks to Darryl at Doosan, got it working.
It is M254 (chuck clamp interlock off)
an M-code that is not in the book!
Go figure.
This worked well for part ejection for me - TT1800SY 31i control. G58 on the lower was always set about .125" off the face of the catcher bucket.
%
O5004(PART UNLOAD SUB)
M310
G58A0.0
M131
M169
M226
M227
M168
G28A0.0
M11
M30
%