[rodyoca]

Hi, this is my first time in the forum. Iv'e recently buy the licence of mach3 and i'm learning how to use it. I'm trying some wizards. all of them have predetermined values, when I try to change any one y click in the box, put the new value hit enter and.... the box change to its original value.
For axample in the Circular Pocket, both the x and y center are 0.000. If I put x=3.00 (for example) when I hit ENTER the value return to 0.0000.

I've tried the write wizard and the same happens.

Any clue.

Thanks
Rodolfo

[ger21]

Are you sure the 3 isn't scrolling off the box to the left due to too many 0's? I've never heard of this problem.

[rodyoca]

thanks ger21.

No, i'm entering the numbers OK, But the problem isn't only with x or y center, If I try to change the tool number to other than 0 it returns to 0 again. the same happens with any other value in any other wizard.

Do I have to register the wizards to get them working or something?
Maybe there are locked or something to do before I can get them runing? As I said Mach 3 is now fully operative with the version 2.0

thanks
Rodolfo

[rodyoca]

Very Sorry for the inconvenience.

I wasn't hit Enter after each entry.

Everithing it's Ok

thanks