Anyone have any experence using 2 flt carbide flat bottom endmills for cutting pockets in h13 steel? And what speeds and feed do you use?
Anyone have any experence using 2 flt carbide flat bottom endmills for cutting pockets in h13 steel? And what speeds and feed do you use?
What brand tool is it?
I would'nt think a two flt would have the geometry your
looking for to machine H13.
Is it coated? Is it heat treated?
All important variables.
PEACE
Actually I was using a cleveland 2flt coated ticn witha high helix to mill deep pocket up to 2" deep running a .050 ramp, 55ipm witha 7850rpm and it worked quuite well. When the tip would start to get dull the operator would touch it up on the grinder and keep going. Worked quite well. Then they discontinued the tool. Murphys law. Get one that works and poof. Now I'm looking for a replacement.
I'll look tommorrow and see if I can find you anything.
Is your material heat treated?
PEACE
no, not heat treated just gummy h13. I realize most people don't run them like this, but it worked really well.
See: http://members.cox.net/camminc/MetalMAX Stability Chart H13.pdf
The link doesn't take me there?
Sorry, I messed up.
Go to http://members.cox.net/camminc/
Go to Chart H13 on that site.